What do i need to hook up subs in my car Installing Subwoofers in a Car

What do i need to hook up subs in my car

Interesting dating site bio

This is the metal wall under the hood of the car, closest to the windshield. This is especially true with newer cars domestic and foreign.

Phil Dodd author Reply Tips Make sure you do not put the fuse in until the end.

Rohtak gay dating site

It takes the high level speaker voltage and drops it to a low level nsw online dating the amplifier can process. Strip the insulation off of the wire at the end where the battery is. Put a fuse into 12v wire in the engine bay no more than 0.

Dating vintage bags

If you really want the best response possible, your subwoofer manual will list the ideal enclosure volume for each type of enclosure. If you follow this guideline, you won't blow up you speakers and improve sound output quality!

They aren't very expensive any more. Dmunegr author Reply This moisture causes the metalwork of the car to rust. If it is a stock stereo on a car without a power antenna and no blue wire, then run the 16 - 18 gauge wire to the fuse box, and connect it to a fuse that turns on when the accessories are on.

Term for younger girl dating older man

Answer this question Flag as Leave the stereo out for the next step. Make sure a large fuse is in the fuse holder.

Introduction: Installing Subwoofers in a Car

It usually requires you either take off the front of the center console, or you use a tool to slide the stereo out of special clips. Make sure you buy a subwoofer box that has a hole the same size as your speaker.

Speed dating application

I won't explain bridging but its easy and you can Google it. Don't worry about it!

7mm mauser dating

Set the subwoofer in the trunk of the car. Run all the wires straight back to the amplifier. I have checked all my fuses and have even opened up the amp case to see if i can figure out whats wrong but nothing looks ab normal.

Double your dating

This can be any device that only works when the ignition is turned on a good example would be the windshield wipers. There should be 2 RCA connections. If there is just one blue wire, you can use that.