Hook up stock radio to amp
The LOC is your input signal. Not Helpful 4 Helpful 8. The other possibility here is your phase is incorrect, are you sure you got positive and negative correct?
You can use this to provide a more solid connection between the subwoofer, amplifier and the battery. What would I connect the rem wire to in this case?
Introduction: Adding RCAs to a Standard Car Head Unit
Run the power wire to your amp. I think he only does this in cars that have a stock amp and have a direct low noise pre-amp level audio signal. Run the red power wire from your amp installation kit from the positive terminal on your battery through your car's cabin to the location of the amp.
First of all, great blog. Everything works fine but sometimes i get a loud humming sound from the subwoofer. Can I connect a kenwood kac to just a sub?
Having a bass knob is nice even if you have an aftermarket stereo. Why does my amp keep blowing fuses even when it is dating a pregnant woman up correctly?
Покупки по категориям
Other wise, probably behind the radio. I have installed a kit like you are talking about, it was 4 or 5 speaker wires that were spliced total. Not Helpful 15 Helpful 7. Thank you for your time and consideration to replying to this question.
Make sure that the corresponding inputs in the subwoofer are paired correctly — negative to negative and positive to positive. Hi Frank, Towards the end of the article I mentioned the option of a separate bass control knob. Hello annie,awesome blog here! You may have to get your signal before or after the amplifier; every car is different and you just need to try it to really see what will work best for your vehicle and application.